DO NOT use this machine unless you have been instructed

in its safe use and operation and have been given permission

Description of Work:

Using a Disc Sander

Potential hazards:

i Abrasions

i Eye injuries

i Excessive dust

i Unsecured material being flung around

PROTECTIVE EQUIPMENT REQUIRED

PRE-OPERATION

ü Check workspaces and walkways to ensure no slip/trip-hazards are present

ü Locate and ensure you are familiar with the operation of the ON/OFF starter and E-Stop (if fitted)

ü Check the table is set not more than 2mm from abrasive disc

ü Check that abrasive disc is in a serviceable condition

ü Fit and adjust the dust collector shroud (where fitted) correctly for maximum efficiency. Start the dust extraction unit before using the machine

ü Faulty equipment must not be used. Immediately report suspect equipment

SAFE OPERATION

ü Allow machine to reach maximum revolutions before operating to avoid overloading

ü Always place material on the table on the downward side of the disc travel to hold it down on the table surface

ü Hold material firmly against the table before applying pressure on abrasive

ü Keep hands/fingers clear of abrasive disc while sanding

ü Before making adjustments switch off and bring the machine to a complete standstill

DON’T

û Never leave the machine running unattended

û Do not sand very small items

û Do not sharpen tools

û Do not sand metal or other materials except wood.